Search
3D printed PVC holder and Geared motor holder (Wrong versions)
- Jo Ravin
- Jan 23, 2018
- 1 min read
We 3d printed a gear motor holder that will be held onto the acrylic surface while the motor turns the PVC pipe.
However the gear motor holder was not high enough and thus we had to print a new one.
The picture below shows the wrong version printed by us.
We also 3D printed a PVC pipe holder that will hold the other end of the PVC pipe while it is spinning,
The mistake in this 3D printed part is that the diameter is too big and thus we need to create a smaller one.
Recent Posts
See Allhttps://docs.google.com/presentation/d/1wBIcCtsc6CuFkqmLf2Aw94WKBNDyq5xGQ4I86G2eMTs/edit?usp=sharing The link above is the google slide...
https://drive.google.com/open?id=1z_sp_2lhezMGFMNJJH3Yqlq80N3kC0aM The following link above contains our Arduino codes, drawings and...
Kommentare