HOME | engineeringdesign5

Presenting:

https://docs.google.com/presentation/d/1wBIcCtsc6CuFkqmLf2Aw94WKBNDyq5xGQ4I86G2eMTs/edit?usp=sharing The link above is the google slide...

https://drive.google.com/open?id=1z_sp_2lhezMGFMNJJH3Yqlq80N3kC0aM The following link above contains our Arduino codes, drawings and...

We finally fixed the issue of the motor shield and got our vessel to maneuver. Here are some videos of our surface vessel in the pool.

Today marks the day of our water craft testing and assessment The videos below are recorded on the day of the assessment. In the video...

How we did it We used hot glue gun to seal off any openings to prevent the motor inside from getting wet, we only need to seal the...

The video below shows the working drill and the working reeling system. We drilled into the sand in the video as well and the drill bit...

We connected the reeling system PVC pipe to the long wires of the drill using connectors and we tested them today. How did we do it?...

At first, our metal reel support does not have this flat metal piece on the top, we added this piece so that the tubing for the...

We used hallow metal square rods to contain the wires from the arduino box, this is so that the wiring is neat and will not be messy.

Today, we tested the arduino circuit it is able to control a drill motor successfully and here is the video with the results. We then...

Blog