HOME | engineeringdesign5

Presenting:

We tested our new gear motor holder and drill bit using a DC voltage source, we input 8V and 2 A into the gear motor and it works fine....

We 3D printed a new motor casing that will house the geared motor we recently bought. And the picture below shows us using a software to...

The Picture below shows the assembled drill with the high torque motor and the actual 3d printed drill, a M3 screw is used to secure the...

We glued an acrylic board onto the top of our Styrofoam vessel, this is because we want to create a platform where we can easily place...

Testing of motors The First video features the Reeling motor (bigger motor) and the Drill motor (small motor). Both motors is able to be...

We were looking for ways on how to secure our transparent plastic container holding the micro-controller onto the surface vessel, We...

We Bought 2 new motors and a transparent lunch box for our vessel. #1 Motors These are the high torque motors we bought, they will be...

Over the weekend we were considering if we could add some features to improve our surface vessel #1 using a bilge Pump. We want to use...

Today we started cutting the Foam using the foam cutter, we made the hull of the surface vessel as well. Here are some images of the...

The new drill We 3d printed a new drill pod and a new drill bit with 100% infill and tested it, and it was able to sink, the gap between...

Blog